|Manufacturer||American Specialties Inc.|
|Special Shipping Type||No|
Tubing: Fabricated of #18 ga stainless steel with a #4 satin finish. Available in 1 1/4” & 1-1/2" outside diameter. All bends are formed by an automatic mandrel bending process. All bars maintain a constant 1 1/2” offset. Finish: Standard finish is a #4 satin finish. Strength: Bars with a 1 1/2” offset clearance will support loads in excess of 900lbs when properly installed. Bars with greater offsets will support loads up to 250lbs when properly installed. Installation: Before installing grab bars, verify with all state and local codes for requirements on bar diameter and type finish. Recommended mounting heights for grab bars are 33” - 36” centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center. Transfer mounting points (3 per flange) to wall. Drill pilot holes and secure bar with proper anchors per application. Snap cover over mounting plate.
Are you looking for commercial hardware? Robert Brooke and Associates specializes in commercial hardware for schools, universities, churches, YMCA, offices, businesses, warehouses and exhibit halls. Order your commercial hardware online by using this site, or call Robert Brooke and Associates for your commercial hardware specialties by phone at (800) 642-2403 weekday from 8AM—5PM Eastern Time. Robert Brooke and Associates ships commercial hardware in the United States, Canada and the world, and has been doing so since 1970. For the best price on commercial hardware with personal service and fast delivery times, call Robert Brooke and Associates
We are using secure Paypal & Authorize.net payment method. You can pay directly from your Credit Card via Authorize.net or Paypal and NEVER store your card information on our site