Keepers and Stops| Mills Toilet Partition
Bathroom Partition Keeper Bumpers and Stops
All keeper bumpers and stops are in stock for fast delivery. We carry in stock chrome plated, cast stainless steel and aluminum partition keeper bumpers. Replacing old hardware with new will change your bathroom's to looking new again. All partition keeper bumpers will come with security screws. All throw latch keepers are required for all handicap doors over 32", 34", 36" width for easy access to the inside door.
-
Mills Keeper Bumper Concealed
Mills Toilet Partition Keeper Bumper For Concealed Latches 1-1/4" Round Edge Post
Polished chrome plate Zamac die casting construction. Strike and Keeper measures 1-1/4" high by 2-3/8" wide by 1-3/4" deep. Stop is 1/2" thick and projects out 1-1/8". The latching slot is 7/16" deep x 3/4" high. This Bathroom Toilet Door Keeper is designed for use on 1-1/4" thick round edge posts or pilasters. Also known as a Bathroom Stall Strike and Keeper for Inswing/Outswing 1-1/4". Manufacture part # 5590.
Shipped with mounting screws.
90T317 -
Mills Keeper Bumper Surface Mount
Mills Keeper Bumper 1-5/8" Between Screws, Surface Mount For Round Edge Posts
Polished chrome plated Zamac die casting. The strike and keeper measure 2-1/4" high by 29/32" wide and 15/16" deep. The hole spacing is 1-5/8" on center. Also known on Bathroom Stall Strike and Keeper Inswing/Outswing 1-1/4". Manufacture part # 5550.
Shipped with mounting screws.
90T316 -
Chrome Plated Keeper Bumper Inswing Flat Stop
Chrome Plated Toilet Partition Keeper Bumper Inswing Flat Stop
Chrome plated Zamac die casting. The strike and keeper measure 2-1/2" tall by 2-9/16" deep and is 1/8" thick. The stop projects out 3/4" and has a rubber insert. The mounting holes are 1-19/32" on center. Also known as a Bathroom Stall Strike and Keeper - Inswing Flat. Flat backed for wall mounting. Manufacture part # 5140
Shipped with mounting screws.
90T116