Search results for: 'rite 780 15 hand'

Horn Bleacher Linkage Arm 22" left hand, Left hand shown in picture.

The Handicap Grab Bar is fabricated of #18 gauge stainless steel with a #4 satin finish.  They are available in 1 1/4” and 1-1/2” outside diameter.  All bars maintain a constant 1 1/2” offset, which is the distance between the inside of the bar and the mounting surface.  The mounting flanges have a 3” diameter.  We offer two types of mounting,  exposed screw mounting and snap on flange concealed. When properly installed they will easily support up to 250 pounds.  The recommended height for mounting these grab bars is 33 to 36” above the finished floor, but heights vary depending on local codes.  The overall length of a 12" grab bar is 15" due to the 3" diameter flanges.  Due to the various materials that these are mounted on, screws are not included.

Toilet partition square edge pilaster shoe split, stamped stainless steel construction. Pilaster Shoe measures 2" to 24" wide by -1-1/4" thick by 3" high. This size pilaster post shoe is split on one end for easy installation. Also known as a bathroom stall pilaster post shoe square edge. Used for the base of the support system with floor mounted pilaster.

A.W. Anderberg 301ST Cadnium Plated Steel HInge

Usually used on commercial hopper windows. If you have a Casement Window, please see the 222SS or the 333SS Egress Window Hinges. This hinge has been discontinued, and is replaced by the 301SS hinge, which has the same hole spacing, length, and stack height.

29/32" wide x 5/8" stack height

Sold Individually, these hinges are non-handed. We recommend that you change both hinges when replacing.

A.W. Anderberg 301SS 4 Bar Window Hinge, with stainless steel construction.

Usually found on commercial aluminum framed windows.

If you have a Casement Window, please see the 222SS or the 333SS Egress Window Hinges

29/32" wide x 5/8" stack height

Sold Individually, these hinges are non-handed. We recommend that you change both hinges when replacing.