Yale 1500 Exit Device
1500-36 For openings up to 36" (0.91m) wide.
1500-48 For openings up to 48" (1.22m) wide.
Strikes 799 Rim Strike (Single Doors)
Stile Minimum Stile width: 4-1/2" (114mm)
Hand Field Reversible1500EO-As low as $2,107.90
Yale 7100 Exit Device
Door Opening Width:
-36 for 30" - 36" (762 - 914mm) doors
-48 for 36-1/2" - 48" (927 - 1219mm) doors
Door Thickness: 1-3/4" (44mm) standard.
Minimum Stile Width: 4-1/2" (114mm)
Projection: 3-1/4" (83mm) active, 2-3/4" (70mm) dogged
Latchbolt: 3/4" (19mm) deadlocking stainless steel Pullman-type
Strike: 757 (panic),7100EO-As low as $1,146.46
Cal Royal 5000 Rim Device
Heavy gauge steel construction, powder coated colors5000EOAs low as $145.42
Can be used with all Doromatic devices. Comes complete with mounting studs (G199002S)
9-1/4" center to center
1-3/4" clearance9970-As low as $132.75
Von Duprin 210K Knob Trim
3" x 4-25/32" x 3/32"220K-As low as $277.58
Von Duprin 210NL Trim
5-3/8" x 4-25/32" x 3/32"
1-31-32" projection220NLAs low as $57.81
Heavy Duty Design
The new Series 2670 Exit Alarm Lock provides secure protection through a large stainless steel deadbolt, which is 2" x 1/2" (51mm x 13mm) and has over a 3/4" (19mm) throw. The engagement area into the strike is over 1 1/4" (32mm) square inches. The cast aluminum latch case protects the internal mechanism and resists tampering or vandalism from inside the door. This unit has been tested to withstand up to 1600 pounds of static load force against the door.
Fits 36" to 48" doors.
Uses 9 volt battery
Ships with all mounting hardware and strike.2670EO-As low as $581.60
Von Duprin 88 Exit Device
Von Duprin 88 rim devices for all types of single and double doors with mullion, UL listed for accident hazard installations. Field reversible, Five popular finishes, ships with 42" crossbar whichis field sizeable, Hex key dogging, 3/4"(19mm)throw latch bolt
Ships with all mounting hardware and strike.88EO-As low as $1,281.41
Von Duprin 373L 88 Lever Trim88L-As low as $579.43
Von Duprin 880TP Trim
The plate measures 3" wide by 14-3/16" long with an 1-5/8" bore hole for cylinder.
Von Duprin part # 880TP-R88TP-As low as $321.37
The Von Duprin 99 rim exit devices for all types of single and double doors with mullion, UL listed for Panic Exit Hardware. Devices are ANSI A156.3 – 2001 Grade 1. The Von Duprin 98 device has a smooth mechanism case and the Von Duprin 99 device has a grooved case. The rim device is non-handed.
Ships with all the mounting screws and the 299 Strike.99EOAs low as $1,224.95
Doromatic replacement pinion gear. This gear is what the key cylinder fits into to actuate the exit device Doromatic Part # CAM.102 and also PB5G199005
Dor-o-Matic top strike.
Used on the Dor-o-Matic 1490, 1690, 1990 and 2390 Concealed Vertical Rod Exit and Panic Devices. The plate measures 1" x 1-1/16" with 4 holes. The mounting holes are 11/16" x 11/16" on center. The diameter of the pin is 7/16" and projects out 5/32". Ships with mounting screws and 3 shim plates.
Doromatic part # PB48G199034$26.55
Dor-o-Matic 1690 Pinion Support Bracket. Bracket holds pinion tip so that it will not slip
Doromatic part # BRKT.478, BRKT.133 or PB312
Dor-o-Matic 1690 Repair Parts BreakdownGPB312$8.85
Doromatic 1690 1790 replacement dogging assy. The dogging assembly is used to dog the door in the open position, so people can enter the building without having to unlatch the door. The kit ships with form threading screws for installation.
Doromatic part # KIT.1197GPBX16
Von Duprin Strike 385A
The Von Duprin 385A Strike is used on the floor for the Von Duprin 2227, 8827, 9827 and 9927 Surface Vertical Rods. The strike face plate outside dimensions are 2-1/4" x 2-1/4" with an inside dimension of 1-1/8" by 1". This floor strike features a bolt that can be cemented into the floor. Zinc plated finish.385A$112.00
Von Duprin Strike 1609
This strike is used when we have a double door application without a center post. By using this strike we can have one door with a surface vertical rod and one door a rim device, which will save money because vertical rods are usually expensive. This strike can be used with the Von Duprin 22/2227, 88/8827, 98/9827 and 99/9927 combinations, but not with the Fire Rated Versions. The strike base measures 1-1/16" wide by 3-1/4" high, the lip projects out 7/8". The three slots are 1-1/4" on center. This strike ships with the mounting screws.
Von Duprin Exit Device 88 Tube Attaching Ring
Von Duprin 55 and 88 Tube Attaching Ring.
Used as a sleeve the wedge tite screw and wedge use to apply pressure to the crossbar. Measures 15/16" long by 13/16" diameter.
Von Duprin Part #090021
Old Part # 96567688R110$10.22
Von Duprin Exit Device 88 Lever Arm Left Hand
Von Duprin 88 replacement lever arm for all the Von Duprin 88 exit devices. The arm includes the Wedge, Wedge Ring, Wedge Tite Screw and Dog Screw, and sometimes the axle.
Von Dupin part # 050439
Old Part # 10072988R70-As low as $214.15
Von Duprin Exit Device 88 Wedge Ring
The Wedge Tite Screw applies pressure on the Wedge which expands the Tube Attaching Ring to grip the Cross Bar. Measures 5/8" on the flat edge.
Von Duprin Part # 090020
Old Part # 95652088R90$6.33
Von Duprin 8827 Top Latch Case for non fire rated doors. This is the part that may be causing your bottom latch to drag on the floor. The Top Latch does all the work on the Von Duprin 8827. When the Top Latch is retracted, it holds the rods in the retracted postion.
Von Duprin part # 050460
Old Part # 10175088VR10$192.00
Von Duprin 8827 Bottom Vertical Rod Assembly
This bottom vertical rod is used on non fire rated doors. The rod includes the bottom rod connector.
Von Duprin Part #050455
Old Part #101777 and 10323488VR150-As low as $127.00
The Von Duprin 22, 33, 33A, 98 and 99 dogging shaft is the current dogging shaft. And has been in production since 1998. If your device is from before 1998, then you would use the 050709. This is the piece that the dogging key would fit into. The shaft is for a 5/32" dog key. #4 on diagram
Von Duprin Part # 090040G090040$9.75
The Von Duprin Dogging Adaptor is the female part that holds the dogging shaft in place.
Von Duprin dogging assebly part
#1 on diagram
Von Duprin part # 090043
Von Dupin 22 Plastic Cap Only
This is the end cap that goes on the hinge side of the door. When the cap breaks off the Dogging Cover Plate just slides off. Works on all of the Von Duprin 22 exit devices. If you need the bracket also, please order part # G22R10. Black plastic contruction. As of October 1, 2014, Von Duprin no longer sells just the Plastic Cap Only. The complete End Cap and Bracket 900981 will be shipped in its place.
Von Durpin Part # 968601G22R25
Von Duprin 2227 Bottom latch.
Replaces and updates all 2227 bottom latches to the new style if you device was shipped before October 1998. If your device was shipped after October 1998 then use the G050401.
Includes screws and bracket
Von Duprin Part # 050090G22VR120
Von Duprin 2227 Latch Cover.
Package includes mounting screws
Von Duprin part # 050566G22VR30-As low as $64.62
Von Duprin 2227 Rod Guide
Works on all of the Von Duprin 2227's, and replaces the older style that featured the plastic cap and the springs.
Von Durpin part # 112063G22VR80-As low as $61.36
Von Duprin 2227 Center Case
Replaces worn out Von Durpin 2227 Center Cases. The Von Duprin 2227 is the 22 Series Device that has the Surface Vertical Rods.
Von Duprin Part # 109358G22VR90$228.21
Von Duprin 5547 Blind Fastener Kit
Connects the rods to the chassis assembly
Includes 2 nuts, 2 bolts 2 washers and 6 screws
Von Duprin Part # 900539G900539$40.36
Von Duprin 9927 Latch Covers.
This cover is used on the 2227, 3327A, 3427A, 9827 and 9927 Exit Devices. Replace old bent and worn covers with brand new ones.
Includes mounting screws
Von Duprin Part # 050566
Other finishes are availableG99VR20-As low as $64.62
Von Duprin Strike 248L-4
The Von Duprin 248L-4 Strike is used as a Bottom Strike on the 2227, 8827, 9927, and 9827 Surface Vertical Rod Panic Devices. The 248L-4 strike measures 9/16" wide by 2-1/2" high with a hole spacing of 1-7/8. The strike projects out 3/8".
Ships with shim and mounting screws
Von Duprin Strike 248L-4
Burnished steel construction248L-4$56.81
Dor-o-Matic 1390 Dogging Assembly. If you have a 1390 and the dogging is stripped, this is the part you need. The 1390 was discontinued in about 2003. The kit includes the dogging cam, activating cam, spacer and retaining ring.
Doromatic part # 4270106669 or PB96 or PB-96G4270106669