Search results for: 'tread cause partit'
-
775 Epoxy Flooring Adhesive
775 EPOXY FLOORING ADHESIVE
The only recommended adhesive for use with Disc-O-Tile. May be used with other rubber stair treads, tile and flooring. Because of flame spread properties, other adhesives will not bond Disc-O-Tile to the floor. A two-part solvent-free adhesive; contains 1 can Part A 1 can Part B, and a stirring paddle. Covers approximately 150 square feet per unit. Enviromental Friendly!
775EPOXY- -
560 Series Rubber Flooring Adhesive
For installing Rubber Floor Tiles or Rolls over suitable on-grade dry concrete floors, suspended concrete floors, or suspended wood floors. May also be used with sanded back molded rubber stair treads. Not recommended where excessive moisture exists; Non-Carcinogenic; Non-Toxic; safe for the environment and freeze thaw stable. See label for complete instructions. Ready to trowel in 1 gallon or 4 gallon cans. Covers 150 square feet per gallon.
560 -
Aluminum Nosing 2 inch with Grit Surface
This 2-1/2" deep nosing is made from the same material as our Grit-Surface Aluminum Treads. The front edge is 1-3/4" deep (inside nose dimension is 1-1/4"). The nose has a 1-3/4" wide abrasive finish with a 3/4" tapered aluminum back edge. Both the nose and tapered edge have a 1/4" wide reflective yellow safety tape strip for additional safety. The nosing is available in abrasive colors of Black, Brown, Blue, Gray, Green, Red or Yellow. Nosing is available solid (for glue-down applications) or with countersunk holes (for screw-down applications) every 12". Nose drops 1-1/16".
SPECIFICATIONS:
Furnish and install Musson Grit-Surface Aluminum Nosings, 3/16" thick X 2-1/2" deep; cut lengths up to 10 foot long. Tread surface shall have aluminum oxide abrasives permanently bonded to a heat treated aluminum nosing with 1/4" wide reflective yellow safety strip on both the top surface (between the grit surface and aluminum) and the nose. Grit surface shall be in one of the following standard colors: Black, Brown, Blue, Gray, Green, Red or Yellow. Nosings can be supplied with two countersunk holes every 12" for screw down installation or without holes for installation with our #400 Neoprene Contact Cement.
Custom sizes are available up to 10' long
GSA2N- -
RCM525 Pressure Sensitive Adhesive
Excelsior PS-525 Modified Pressure Sensitive adhesive is an acrylic adhesive that can be used as a wet-set, tacky-wet, or dry-set pressure sensitive adhesive for the permanent installation of dimensionally stable Resilient flooring products over porous and non-porous substrates in indoor applications; it is a low odor, non-flammable, solvent-free and ready to use product. We are recommending the 1/16” X 1/16” X 1/16” square notch trowel which yields 150 square foot/gallon coverage; the resulting installation will end up with a non-releasable firm-set adhesive bond.
Access Times:
Heat Welding ≥ 24 Hours
Light Foot Traffic ≥ 24 Hours
Heavy Foot Traffic and Rolling Loads ≥ 48 Hours
Maintenance ≥ 72 Hours1 Gallon covers approximately 150 square feet.
RCM525-
