Search results for: 'bars latch part 9001'
-
Von Duprin Exit Device 22 End Cap Only 968601
Von Dupin 22 Plastic Cap Only
This is the end cap that goes on the hinge side of the door. When the cap breaks off the Dogging Cover Plate just slides off. Works on all of the Von Duprin 22 exit devices. If you need the bracket also, please order part # G22R10. Black plastic contruction. As of October 1, 2014, Von Duprin no longer sells just the Plastic Cap Only. The complete End Cap and Bracket 900981 will be shipped in its place.
Von Durpin Part # 968601
G22R25 -
Global Top Hinge For Flat Surface
Global Partitions Top Hinge For Flat Surface Mounting. Chrome plated Zamac die cast construction. Used with powder coated steel and stainless steel partition doors. Pivot hinge is 2-3/16" tall by 1-1/2" wide. The hole spacing is 1-1/2" on center. The lug projects out 1-1/2" and is 1/2" thick. The bushing on the lug is 3/8" diameter. Manufacturer part # 135580. Same part for Flush Metal and General Partitions. Shipped with mounting screws. A=1-7/6". Also used with Accurate Partition doors after January 2013.
9G0202 -
Sargent Exit Device Lever Return Spring
Sargent Exit Device Lever Return Spring
This spring is used on Sargent Lever Trims for there Exit Devices.
2-1/8" LONG
Sargent part # 97-0425
G970425 -
Lyon Folding Chairs-Attaching Hardware
Lyon Folding Chairs metal Attaching Hardware set for all 4 legs. This is necessary to keep the chair tip in place. Lyon part number 1598.
KGL33 -
Doromatic Exit Device 1690/1990 Retractor
Doromatic retractor. The pinion rides inside this bracket to raise and lower the internal rods. Parts used with the retractor are the Pinion (G199005), Traveller (G199028) and the Pinion Bushing (G199046). Retractor measures 1-7/8" long by 7/8" wide by 1/4" thick.
Doromatic part # PB35 or RETRACT.101
G199035 -
Cal Royal 2000 Alarmed Exit Device
Cal Royal 2000 Alarmed Exit Device
Alarm units has an internal horn. When the push rail is depressed, the horn sounds to provide an audible means of signaling that the door has been opened and violated. The unit has changeable 2 minute alarm cutoff or manual reset. Preset at factory for 2 minute alarm cut off. Jumper cable is provided to swich to continuous alarm. The key switch to turn the alarm off is a standard 1” cylinder with “C” keyway. The alarm operates on one standard 9 volt transistor battery. When battery is weak the horn will emit an intermittent signal. Alarmed units are supplied with two switches. One switch monitors the push rail and the other switch monitors the latch bolt for full proof security.
Unit includes “EMERGENCY EXIT ONLY. ALARM WILL SOUND” decal for application on door or unit.ALM2000
