Search results for: 'cast a gas emco resist'

Non-fading superior aging properties make this oil, grease, chemical and stain resistant matting a popular item. Non-combustible; tear, cut, impact and ozone resistant; high tensile strength and elongation properties; single piece rolls. Use inside or outside. Round ribbed corrugations run lengthwise, easily cleaned with soap and water.

GREASE AND OIL RESISTANT — NO FABRIC

Pricing below is per linear feet, Black Only, Size is the Width

320 CARPET TILE ADHESVIE

A special latex emulsion pressure sensitive adhesive formulated for installation of modular carpet tiles or carpet matting. Adhesive is non-flammable, water resistant and has excellent resistance to vinyl plasticizer migration. Adhesive remains tacky for an extended period - allows tile to be picked up and replaced without affecting adhesive. Remove tiles from floor more easily than with conventional adhesives, simplifying reinstallation of tile sections or a complete area.

Covers 200 to 300 square feet per gallon
Sold in 1 or 4 Gallon Pails

334 Vinyl Stair Tread 24" Brown

Lightweight, economy gauge with a round rib design. Wear and tear resistant Vinyl Stair Treads will give years of service; compares with heavier weight treads. Curve-around nose fits round or square nose steps. Intended for residential or light commercial use.

SPECIFICATIONS:

#334 Koroseal Vinyl economy stair treads, round rib surface design, approximately 5/64" thick, 10" deep with curve-around nose;

Standard narrow corrugated surface is completely tested through- out. Conforms to ANSI/ASTM D178 J6.7 Type II Class 2. Stays in place, is slip resistant. With care, lightweight carts can be used over this runner.

Meets Dielectric Test Volt, RMS AC 30,000; Proof Test Volt, RMS AC 20,000. Recommended maximum use Volt, RMS AC 17,000.

Fully meets ASTM specifications branded on back. Black color only. Available in standard rolls or cut to exact length desired.

Sold by the foot

FLUFF-CORD STRIP TILE

A close-nap carpet-like surface of specially processed rubber-fabric strips made from recycled heavy-duty truck and bus tires; Natural Earthtone Gray Color. Strips are heat bonded to a woven flexible backing. This creates a "dry-back" adhesive back that reacts with our non-flammable adhesive to form a stronger bond to the floor. Install this permanent entry floor mat inside or outside; cord strips act as a wiper where dirt or moisture is a problem; are non-skid, non-absorbing, resist shrinkage, deaden sound. Ideal for heavy wear areas in shopping centers, lobbies, entryways, ramps, airports, etc. Produced in standard 12" x 12" tile size.

Tile must be installed using manufacturer's specific installation instructions and Musson No. TT-390 Non-Flammable Environmentally Safe Adhesive.

Order Fluff-Cord Strip Tiles here

FLUFF-CORD STRIP TILE-CONTINUOUS STRIP

A close-nap carpet-like surface of specially processed rubber-fabric strips made from recycled heavy-duty truck and bus tires; Natural Earthtone Gray Color. Strips are heat bonded to a woven flexible backing. This creates a "dry-back" adhesive back that reacts with our non-flammable adhesive to form a stronger bond to the floor. Install this permanent entry floor mat inside or outside; cord strips act as a wiper where dirt or moisture is a problem; are non-skid, non-absorbing, resist shrinkage, deaden sound. Ideal for heavy wear areas in shopping centers, lobbies, entryways, ramps, airports, etc. Produced in longitudinal rolls 12" wide x 25' long.

Tile must be installed using manufacturer's specific installation instructions and Musson No. TT-390 Non-Flammable Environmentally Safe Adhesive.

Order Fluff-Cord Strip Rolls here

Ideal for residential and light commercial applications. This is one of our favorite stair treads for the do-it-yourselfers. Easy to install with very easy cutting, ideal for basement steps. Lightweight, economy gauge with a round rib design. Curve-around nose fits round or square nose steps. Made in the USA.

Specifications:

• #334 Koroseal Vinyl economy stair treads
• Round rib surface design
• Thickness: 5/64"
• Depth: 10"
• Curve-around nose
• Sizes available: 18", 24", 36", 48" or 72"
• Colors available: Brown, Black

Vinyl Stair Treads GS365 with Grit Strip

This is one our highest volume vinyl stair treads. Heavy duty to stand up to most applications with the safety of inlaid grit strips. Made in the USA

SPECIFICATIONS:

Furnish and install No. GS365 Koroseal Vinyl Stair Treads
Grit-Strip rib design stair treads; 7/32" thick, 12" deep; 1-1/4" square nose; two black* 1" wide abrasive Grit-Strips inlaid in tread, 1" from front edge, spaced 1-1/4" apart; contains no asbestos fiber; made of first quality homogenous vinyl, color throughout thickness; free from imperfections which might lessen serviceability. Meets Federal Specs. RR-T-650E Type B. Select standard length of 36", 42", 48", 54", 60", 72", 84" or 96". Select standard solid color of Brown or Gray.