Keepers and Stops| Fiat Toilet Partition
Bathroom Partition Keeper Bumpers and Stops
All keeper bumpers and stops are in stock for fast delivery. We carry in stock chrome plated, cast stainless steel and aluminum partition keeper bumpers. Replacing old hardware with new will change your bathroom's to looking new again. All partition keeper bumpers will come with security screws. All throw latch keepers are required for all handicap doors over 32", 34", 36" width for easy access to the inside door.
-
Fiat Keeper Bumper For 1-1/4" Inswing Sq Edge
Fiat Toilet Partitions Keeper Bumper For 1-1/4" Inswing Sq Edge Pilaster Or Post
Zamac die casting that is polished chrome plated. The strike and keeper is 2-1/2" tall by 1-7/8" wide. The stop sticks out 3/4" and has a rubber bumper on it. The two mounting screws are 1-1/2" on center. The latch bolt slot is 1-9/16" high by 5/16" deep. This keeper bumper is designed for use on a 1-1/4" Post or Pilaster for inswinging doors. Also known as a Bathroom Stall Strike and Keeper-Inswing 1-1/4". Manufacture part # 5110
Shipped with mounting screws.
9F0304 -
Fiat Keeper Bumper Out Swing for 1-1/4"
Fiat Partitions Keeper Bumper For 1-1/4" Outswing Square Edge Pilaster Or Post
Zamac die casting that is polished chrome plated. The strike and keeper is 2-1/2" tall by 1-7/8" wide. The stop sticks out 3/4" and has a rubber bumper on it. The two mounting screws are 1-1/2" on center. This keeper bumper is designed for use on a 1-1/4" Post or Pilaster for outswinging doors. Also known as a Bathroom Stall Strike and Keeper-Outswing 1-1/4". Manufacture part # 5210
Shipped with mounting screws.
9F0303 -
Fiat Keeper Bumper Concealed
Fiat Partitions Keeper Bumper Concealed And Strike For Concealed Latches Inswing/Outswing 1-1/4"
Zamac die cast and polished chrome plate construction. Keeper is 1-1/4" tall by 2-3/8" wide by 1-3/4" deep. The strike is a1/2" thick and the slot is 7/16" deep. The opening to mount it on the square edge pilaster or post is 1-1/4" by 1-1/4" Also known as a Bathroom Stall Strike and Keeper for Inswing/Outswing 1-1/4". Manufacture part # 5960
Shipped with screws for mounting.
Same as the 9S8861
9F0227
